78-19994-01 Edge MXP Installation Sheet, March 2011
© 2011 Cisco Systems, Inc. All rights reserved.
Edge
MXP
Wall mounting instructions
Mount the Edge MXP codec (with all cables connected) onto the bracket. Use the wall bracket screw to fasten the unit.
Mount the monitor and camera back in place. Camera mounting instructions are
printed overleaf.
Connect the cables as illustrated overleaf.
Unscrew the base using the enclosed screwdriver.
Put Edge MXP codec on its
back.
Mount the bracket on the wall.
Remove the monitor.
Decide where to mount the Edge MXP codec.
CAUTION:
Equipment needed
The recommended
mounting is here:
DO NOT MOUNT IT HERE!
Alternative
mounting
Alternative
mounting
Cable management
Make sure there is space
for all cables when the
monitor is put back in
place. Also make sure that
the cable connections will
be well hidden behind the
monitor.
Recommended
Alt. 1
Alt. 2
Bracket with screw
(included).
Screwdriver to remove
the base and mount the
bracket (included).
Suitable screws (at least
4×15) to mount bracket
on wall (not included).
Each screw must be
able to sustain at least
10 kg when bracket is
mounted.
Screwdriver to mount
bracket on wall (not
included).
1
2
3
4
5
6
7
8
Hose (sleeve) to
accommodate the
cables between the
codec and the monitor
and camera (included).
Use screws in
all four holes for
mounting. Do not
rely on the center
hole alone.
CAUTION:
Do never use other screws than the 20 mm screw already attached to the wall bracket. Do not
remove this screw. Using other screws may damage the codec’s interior and will void the warranty.
PrecisionHD
camera
Microphone
Monitor
Power supply
LAN/Ethernet
PC/Laptop
Mounting the codec to
the left of the monitor
Alternative
mounting
Alternative
mounting
