Configuring the Cisco SPA8800 IP Telephony Gateway in an Asterisk Environment
© 2009 Cisco Systems, Inc. All rights reserved.
Page 26 of 69
SPA8800 Debug and syslog
The SPA8800 supports writing debug and syslog messages to syslog servers. One server can be
used, or separate servers can be used to receive messages. Four levels of verbosity are
supported, 0 for no messages, 1 for terse, through 3 for verbose message output:
Following is an example of syslog information produced at Debug Level 3 [numbers changed]. This
example shows when the phone goes off hook, digits dialed, calling information, a report that an
unlisted codec is being requested, and when the phone goes back on hook:
M0: [0]Off Hook
M0: 2. Report digit 8 (1)(40 ms)
M0: 2. Report digit 5 (1)(40 ms)
M0: 2. Report digit 5 (1)(40 ms)
M0: 2. Report digit 5 (1)(40 ms)
M0: 2. Report digit 1 (1)(40 ms)
M0: 2. Report digit 2 (1)(40 ms)
M0: 2. Report digit 1 (1)(40 ms)
M0: 2. Report digit 2 (1)(40 ms)
M0: Calling:[email protected]:0
M0: [0:0]AUD ALLOC CALL (port=16404)
M0: [0:0]RTP Rx Up
M0: CC:Ringback
M0: [0:0]RTP Rx Dn
M1: CC:pc(0)=18 not in codec list
M1: AUD:Stop PSTN Tone
M0: CC:Ringback
M2: [1:0]AUD ALLOC CALL (port=18457)
M2: [1:0]RTP Rx Up
M2: AUD:Stop PSTN Tone
M2: CC:Connected
M2: AUD:Stop PSTN Tone
M2: [1:0]ENC INIT 0
M2: [1:0]RTP Tx Up (pt=0->c0a80214:19926)
M2: [1:0]RTCP Tx Up
M0: [0:0]ENC INIT 0
M0: [0:0]RTP Tx Up (pt=0->c0a80214:19046)
M0: [0:0]RTCP Tx Up
M0: CC:Remote Resume
M2: FXO:Off Hook
M2: FXO:Stop CNDD
M0: CC:Connected
M0: [0:0]RTP Rx Up
M0: [0:0]RTP Rx 1st PKT @16404(2)
M2: [1:0]RTP Rx 1st PKT @18457(2)
M0: [0:0]DEC INIT 0
M2: [1:0]DEC INIT 0
M2: FXO:CPC
M2: AUD:Stop PSTN Tone
M2: FXO:On Hook
M2: FXO:Stop CNDD
M2: AUD:Stop PSTN Tone
M2: [0]FM Alert Stop RxTx (c=002b5f38;a=0)
