Chapter 1 Cisco SB 106 Router Cabling and Setup
Try to Connect to a Website
1-8
Cisco SB 106 Router Cabling and Setup
78-16773-01
Warning
This product relies on the building’s installation for short-circuit (overcurrent)
protection. Ensure that a fuse or circuit breaker no larger than 120 VAC, 15A U.S.
(240 VAC, 16A international) is used on the phase conductors (all
current-carrying conductors).
Warning
This equipment is intended to be grounded. Ensure that the host is connected to
earth ground during normal use.
Try to Connect to a Website
Log in to a PC that is connected to the router, open a web browser, and connect to
a website. If you successfully access a website, you do not need to change the
configuration and you have completed setup. If you cannot access a website,
follow the steps in the
“Configure the Router” section on page 1-8
.
Configure the Router
Configure the router by following the instructions in the
Cisco Router and
Security Device Manager (SDM) Quick Start Guide
. This document shows you
how to connect your PC to your router and how to use SDM, a configuration tool
that you run from your web browser.
Additional information about SDM is available at the following URL:
www.cisco.com/go/sdm
Click the Technical Documentation link to view release notes and other SDM
documentation.
