Cisco Remote PHY Shelf 7200, Software Configuration Manual And Command Reference

Page: 22 / 116

Configuring DHCP Server using IPv6 Stateless
The Cisco Remote PHY System supports the Stateless Address Auto Configuration (SLAAC). IPv6 address
assignment of the RPD is governed by the configuration bits set in the ICMPv6 Router Advertisement (RA)
message and the presence of a valid prefix in the Prefix Information Option (PIO). For more information
about RPD IPv6 address assignment, refer to section 6.7 of Remote PHY Specification.
To configure DHCP server using IPv6 Stateless and enable SLAAC, follow the steps below:
1. Configure Prefix Type to “stateless” in CNR prefix.
2.
Configure ICMPv6 Router RA message M Bit=0 and O Bit =1.
It is recommended that you follow the DHCP options listed in Table 2 - Router Advertisement M Bit and O
Bit Settings For SLAAC of section 6.7.1 (CM-SP-R-PHY-I10) or 6.6.1 (CM-SP-R-PHY-I11) in the Remote
PHY Specification.
Note
To display the RPD get IPv6 address by SLAAC, use the show dhcp command.
R-PHY#show dhcp
Interface
IP-Address Subnet-Mask
vbh0 2001:93:3:58:1204:9fff:fec1:100 ffff:ffff:ffff:ffff::
Details:
--------------------------------------------------------------------------------
Interface:
vbh0
AddrType: IPv6<Stateless>
TimeServers: 2001:20:1:1::33
TimeOffset: 28800
LogServers: 2001:20:1:1::33
CCAPCores: 2001:93:3:58::1
Configuring DHCP Server using IPv6 Stateful
To configure DHCP server using IPv6 Stateful, follow the steps below:
1. Configure Prefix Type to “dhcp” in CNR prefix. See the following image.
2. Configure ICMPv6 Router RA message M Bit=1.
Cisco Remote PHY Shelf 7200 Software Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
10
Cisco Remote PHY Shelf 7200 Start Up Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
Configuring DHCP Server using IPv6 Stateless