Cisco PVDM2-12DM, PVDM2-24DM, and PVDM2-36DM Digital Modem Packet Voice Data Modules
show modem configuration (pvdm2)
33
Cisco IOS Release 12.4(9)T, 12.4(11)XW, and 12.4(20)T
S06
Wait Time Before Blind Dialing
2 to 255 seconds. Default/minimum is 2.
S07
Wait Time for Carrier, Silence,
or Dial Tone
1 to 255 seconds. Default is 50.
S08
Pause Time for Dial Delay
0 to 255 seconds. Default is 2.
S09
Carrier Detect Response Time
1to 255 in 100 ms increments. Default is 6
(0.6 seconds).
S10
Lost Carrier to Hangup Delay
1 to 255 in 100 ms increments. Default is 14
(1.4 seconds).
S11
DTMF Tone Duration
Returns OK. Default is 95 (0.095 seconds).
S12
Escape Prompt Delay (EPD)
Returns OK. Default is 50 (1.00 seconds).
S14
General Bit Mapped Options
Status
Sets/resets command echo, quiet mode, result codes,
tone/pulse, originate/answer.
S16
General Bit Mapped Test
Options Status
Status of analog and digital loopback tests.
S18
Test Timer
Length of test before returning to command mode.
0 to 255 seconds. Default is 0.
S21
V24/General Bit Mapped
Options Status
Status of behavior of CTS, DTR, DCD, and DSR.
S22
Speaker/Results Options Status
Not supported.
S23
General Bit Mapped Options
Status
Status of RDL, DTE rate, DTE parity, and guard tone.
S24
Sleep Inactivity Timer
0 to 255 seconds. Default is 0 (no sleep).
S25
Delay to DTR
0 to 255 in 10 ms increments (or full seconds for
synchronous modes). Default is 5.
S26
RTS to CTS Delay
0 to 255 in 10 ms increments. Default is 1.
S27
Bit Mapped Options Status
Sync/async selection, leased line control, clock select,
CCITT/Bell mode select.
S28
Bit Mapped Options Status
Pulse dialing make/break ratio. Default is 39 - 61% at
10 pulses/second.
S29
Flash Dial Modifier Time
0 to 255 in 10 ms increments. Default is 70
(0.7 seconds).
S30
Disconnect Inactivity Timer
0 to 255 in 10 second increments (0 to 2550 seconds).
Default is 0 (disabled).
S31
Bit Mapped Options Status
Single line connect message, auto line speed detect,
error correction progress message.
S32
XON Character
Default is 0x11.
S33
XOFF Character
Default is 0x17.
S36
LAPM Failure Control
Indicates activity on a LAPM failure.
S37
Desired Line Connection Speed
Default is 0 (automode connection).
S38
Delay Brfore Forced Hangup
0 to 255 seconds. Default is 20.
Table 2
show modem configuration Field Descriptions for V12 Modems (continued)
S Register
Field
Description
