Cisco PVDM2-12DM, PVDM2-24DM, and PVDM2-36DM Digital Modem Packet Voice Data Modules
show modem configuration (pvdm2)
31
Cisco IOS Release 12.4(9)T, 12.4(11)XW, and 12.4(20)T
show modem configuration (pvdm2)
To display the current modem configuration for digital modems on PVDM2-xxDM devices, use the
show modem configuration
command in privileged EXEC mode.
show modem
configuration
[
slot
/
modem number
]
Syntax Description
Command Modes
Privileged EXEC
Command History
Examples
The following is sample output from the
show modem configuration
command for a V12 modem. A
specific modem, 0/322, is designated.
Router#
show modem configuration 0/322
Modem (0/322) Configuration Status:
S-Reg Value Meaning
-------|-------|---------------------------------------------
S00 = 0 Auto Answer disabled
S01 = 0 Ring Counter is 0
S02 = 43 escape character is 0x2B or '+'
S03 = 13 carriage return character is 0xD
S04 = 10 line feed character is 0xA
S05 = 8 backspace character is 0x8
S06 = 2 pause 2 seconds before blind dialing
S07 = 70 wait up to 70 seconds for carrier after dialing
S08 = 2 comma adds 2 second dial delay
S09 = 6 0.6 second Carrier detect response time
S10 = 14 1.4 second delay for hangup after carrier loss
S11 = 95 0.095 second DTMF Tone Duration
S11 = 50 Escape Prompt Delay (in .02s)
S14 = 138 Command echo enabled (E1), Send result codes (Q0),
Result codes is verbose (V1), Tone (T), Originate,
S16 = 0 Local analog loopback disabled
Local digital loopback disabled
Remote digital loopback not in progress RDL not requested
RDL with self test disabled
Local analog loopback with self test disabled
S18 = 0 Test Timer = 0x0, test will not terminate if zero
S21 = 52 Set by &J0 command but ignored otherwise,
CTS always on (&R1), DTR behavior &D2 selected,
RLSD (DCD) behavior &C1 selected,
DSR behavior &S0 selected Long space disconnect Y0,
S22 = 119 Speaker/Results 0x77 not supported
S23 = 54 RDL not allowed (&T5), DTE Rate 2400 bps,
Assumed DTE parity none, Guard tone none (&G0),
slot
/
modem number
(Optional) Slot and modem number. If this number is not specified, statistics
for all connected modems are displayed. You must type in the forward slash
(
/
).
Release
Modification
12.4(11)XW
This command was introduced.
