67
Performance Route Processor Installation and Configuration Guide
OL-11656-01
Additional Configuration and Maintenance Tasks
Removing and Installing a Compact Flash Disk
Note
You must remove the PRP-2 before you can remove or install a compact flash
disk. The compact flash disk is only supported on the PRP-2.
To remove a compact flash disk (CF) from the PRP-2 board, follow these steps:
Step 1
Loosen the screw fastening the retaining bracket for the CF. (See
Figure 18
.)
Step 2
Lift the end of the retaining bracket out of the hole that holds it in place flush with
the CF, and swivel it around until it is not in the way of removing the CF. (See
Figure 18
.)
Step 3
Press lightly on the CF and push it out of its socket in the direction of the retaining
bracket. (See
Figure 18
.)
Figure 18
Removing the CF from the PRP-2 Board
Step 4
Once the CF is released from the socket, pull it completely out of the board.
Step 5
If you are not inserting another CF into the socket on the board, replace the
retaining bracket by swivelling it back around until the end rests in the hole on the
PRP-2 board and fastening the screw into the board.
101106
