4-8
PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration
OL-3526-05
Chapter 4 Configuring Unchannelized mode for the Cisco PA-MC-2T3+
Configuring an Unchannelized T3 Link
Examples of MDL Message Configuration
Examples of configuring MDL messages follow:
•
Enter interface configuration mode first.
The example that follows is for a port adapter on a VIP in interface processor slot 1:
Router#
configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#
interface serial 1/0/0
Router(config-if)#
The example that follows is for a port adapter in slot 1 of the Cisco 7200 series routers:
Router#
configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#
interface serial 1/0
Router(config-if)#
•
Enable the MDL path message transmission as follows:
Router(config-controller)#
mdl transmit path
•
Enable the MDL idle signal message transmission as follows:
Router(config-if)#
mdl transmit idle-signal
•
Enable the MDL test signal message transmission as follows:
Router(config-if)#
mdl transmit test-signal
•
Enter the equipment identification code as follows:
Router(config-if)#
mdl string eic
router A
•
Enter the location identification code as follows:
Router(config-if)#
mdl string lic
tst network
•
Enter the frame identification code as follows:
Router(config-if)#
mdl string fic
building b
•
Enter the unit identification code as follows:
Router(config-if)#
mdl string unit
abc
•
Enter the facility identification code to send in the MDL path message as follows:
Router(config-if)#
mdl string pfi
string
•
Enter the port number to send in the MDL idle signal message as follows:
Router(config-if)#
mdl string port
string
•
Enter the generator number to send in the MDL test signal message as follows:
Router(config-if)#
mdl string generator
string
