3-14
Operation
OL-29669-01
Operating using Console Software
This section introduces the procedures to use the OptoStar II console to manage
the OptoStar II RF switch module.
Before You Begin
One PC
Mini-USB data cable
OptoStar II console software installation package
System Requirements
Supported operation system:
Windows 7, Windows Vista, Windows Server
2003, and Windows XP
Processor:
400 MHz Pentium or equivalent processor (minimum requirement);
1 GHz Pentium or equivalent processor (recommended)
Memory:
96 MB (minimum requirement); 256 MB (recommended)
Hard drive:
500 MB free space required
Monitor:
800 x 600, 256-color (minimum requirement); 1024 x 768 high color,
32-bit (recommended)
Start
1.
Make sure that the RF cables of the OptoStar II RF switch module have been
connected.
2.
Turn the front panel switch of the OptoStar II power supply module to ON
position. The power supply module and the RF switch module will initialize
for about 5 seconds, and the ICIM will load for about 25 seconds.
Note:
The system will achieve optimal working condition after one hour’s
warm-up.
Continued on next page
