12-3
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 12 Add and Remove Cards and Nodes
DLP-G254 Place OPT-BST and OPT-PRE Ports Out of Service
Step 7
Continue with the
“NTP-G34 Install Fiber-Optic Cables on DWDM Cards and DCUs” procedure on
Step 8
Complete the following tasks or procedures, as needed:
•
If you switched a Y-cable protection group in
, complete the
Force Y-Cable or Splitter Protection Switch” task on page 10-36
•
If you deleted circuits in
, complete the
“DLP-G105 Provision DWDM Optical Channel
Network Connections” task on page 7-10
.
•
If you switched the timing reference in
, complete the
“NTP-G112 Change the Node Timing
Reference” procedure on page 13-17
•
If you deleted an OSC or GCC termination in
, complete the
Terminations” procedure on page 3-84
or the
“DLP-G76 Provision GCC Terminations” task on
•
If you placed OPT-PRE or OPT-BST cards out of service, complete the
and OPT-PRE Ports In Service” task on page 12-4
.
Step 9
Click the
Alarms
tab.
a.
Verify that the alarm filter is not on. See the
“DLP-G128 Disable Alarm Filtering” task on page 8-28
as necessary.
b.
Verify that no unexplained alarms appear on the network. If alarms appear, investigate and resolve
them. Refer to the
Cisco ONS 15454 Troubleshooting Guide
or the
Cisco ONS 15454 SDH
Troubleshooting Guide
for procedures.
Stop. You have completed this procedure.
DLP-G254 Place OPT-BST and OPT-PRE Ports Out of Service
Step 1
On the shelf graphic in CTC, double-click the OPT-BST or OPT-PRE card with the ports that you want
to put out of service.
Step 2
Click the
Provisioning
>
Optical Line > Parameters
tabs.
Step 3
Under Admin State, choose
OOS,DSBLD
(ANSI) or
Locked,disabled
(ETSI) for each port that does
not have an OOS-MA,DSBLD or Locked-disabled service state.
Step 4
Click
Apply
.
Step 5
In the confirmation dialog box, click
Yes
.
Step 6
Click the
Provisioning
>
Opt Apli Line > Parameters
tabs.
Purpose
This task places OPT-BST and OPT-PRE card ports out of service in
preparation for card removal.
Tools/Equipment
None
Prerequisite Procedures
DLP-G46 Log into CTC, page 2-25
Required/As Needed
As needed
Onsite/Remote
Onsite or remote
Security Level
Provisioning or higher
Summary of Contents for ONS 15454 DWDM
Page 38: ...Figures xxxviii Cisco ONS 15454 DWDM Installation and Operations Guide R6 0 August 2005 ...
Page 54: ...Procedures liv Cisco ONS 15454 DWDM Installation and Operations Guide R6 0 August 2005 ...
Page 64: ... 64 Cisco ONS 15454 DWDM Installation and Operations Guide R6 0 August 2005 Chapter ...