Cisco ONS 15454 DWDM, Installation And Operation Manual

Page: 661 / 1218

13-17
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 13 Maintain the Node
NTP-G110 Off-Load the Diagnostics File
NTP-G110 Off-Load the Diagnostics File
Step 1 Complete the “DLP-G46 Log into CTC” task on page 2-25 at the node where you want to off-load the
diagnostics file. If you are already logged in, continue with Step 2 .
Step 2
In node view, click the Maintenance > Diagnostic tabs.
Step 3
Click Retrieve Tech Support Log .
Step 4
In the Saving Diagnostic File dialog box, navigate to the directory (local or network) where you want to
save the file.
Step 5 Enter a name in the File Name field.
You do not have to give the archive file a particular extension. It is a compressed file (gzip) that can be
unzipped and read by Cisco Technical Support.
Step 6 Click Save .
The Get Diagnostics status window shows a progress bar indicating the percentage of the file being
saved, then shows “Get Diagnostics Complete.”
Step 7
Click OK .
Stop. You have completed this procedure.
NTP-G112 Change the Node Timing Reference
Step 1
Complete the “DLP-G46 Log into CTC” task on page 2-25 at the node where you want to enable timing
switching. If you are already logged in, continue with Step 2 .
Purpose This procedure describes how to off-load a diagnostic file. The diagnostic
file contains a set of debug commands that were run on a node and their
results. This file is useful to the Cisco Technical Assistance Center (TAC)
when troubleshooting problems with the node.
Tools/Equipment None
Prerequisite Procedures None
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Maintenance or higher
Purpose This procedure enables automatic timing reference switching or returns
the node timing to normal operation.
Tools/Equipment None
Prerequisite Procedures NTP-G53 Set Up Timing, page 6-4
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Maintenance or higher