Cisco NCS 1001, Start Manual, Page: 23 / 40

b) If the post width is 3", modify the right/left sliders as shown below.
Step 2 Prepare the two post slider.
Figure 16: Two Post Slider Preparation
Align the rivet with key hole. 2
Do not insert any rivet inside this. 3
a) Unfasten the 4X screws as shown above.
b) Align the shoulder rivet with the key hole as shown.
c) Fasten all the 4X screws again.
The two post slider is ready to use on 3" width post. This assembly procedure is the same for right or left sliders.
23