xvii
Cisco MGX 8950 Hardware Installation Guide
Release 2.1, Part Number 78-11273-01 Rev. B0, March 2002
About this Guide
Related Documentation
Cisco MGX 8850 Release 2.1 Documentation
The product documentation for the installation and operation of the MGX 8850 Release 2.1 switch is
listed in
Table 3
.
Table 3
Cisco MGX 8850 Switch Release 2.1 Documentation
Title
Description
Cisco MGX 8850 Routing Switch Hardware Installation
Guide, Release 2.1
DOC-7812561=
Describes how to install the MGX 8850 routing switch. It
explains what the switch does, and covers site preparation,
grounding, safety, card installation, and cabling.
Cisco MGX 8850 and MGX 8950 Switch Command
Reference, Release 2.1
DOC-7812563=
Describes how to use the commands that are available in the
CLI
1
of the MGX 8850 and MGX 8950 switches.
1.
CLI = command line interface
Cisco MGX 8850 and MGX 8950 Switch Software
Configuration Guide, Release 2.1
DOC-7812551=
Describes how to configure the MGX 8850 and the MGX 8950
switches to operate as ATM edge and core switches. This guide
also provides some operation and maintenance procedures.
Cisco MGX 8850 and MGX 8950 SNMP Reference,
Release 2.1
DOC-7812562=
Provides information on all supported MIB
2
objects, support
restrictions, traps, and alarms for the AXSM, PXM45, and RPM.
PNNI is also supported.
2.
MIB = Management Information Base
Cisco MGX and SES PNNI Network Planning Guide
DOC-7813543=
Provides guidelines for planning a PNNI network that uses the
MGX 8850 and the MGX 8950 switches and the BPX 8600
switches. When connected to a PNNI network, each BPX 8600
series switch requires a Service Expansion Shelf (SES) for PNNI
route processing.
Cisco MGX Route Processor Module Installation and
Configuration Guide, Release 2.1
DOC-7812510=
Describes how to install and configure the MGX Route Processor
Module (RPM-PR) in the MGX 8850 and MGX 8950 Release 2.1
switch. Also provides site preparation, troubleshooting,
maintenance, cable and connector specifications, and basic IOS
configuration information.
