Cisco M190, Quick Start Manual

Page: 5 / 14

5
Install the Appliance in a Rack
Install the Cisco M190 Content Security Management Appliance following the
instructions in the
Cisco x90 Series Content Security Appliances Installation and
Maintenance Guide .
Appliance Placement
•
Ambient Temperature—To prevent the appliance from overheating, do not
operate it in an area that exceeds an ambient temperature of 104°F (40°C).
•
Air Flow—Be sure that there is adequate air flow around the appliance.
•
Mechanical Loading—Be sure that the appliance is level and stable to avoid
any hazardous conditions.
Temporarily Change Your IP Address for Remote
Access
To remotely configure the Cisco M190 using the network connection, you must
temporarily change the IP address of your computer. Alternatively, you can use
the serial console to configure the Cisco M190, without changing the IP address.
If you use the serial console, proceed to section below.
Note
Make a note of your current IP configuration settings as you will need
to revert to these settings after you finish the configuration.
For Windows
The exact steps depend on your operating system version.
Step 1
Go to the Start menu and choose Control Panel .
Step 2
Click Network and Internet , then Network and Sharing Center .
Step 3
Click the Change adapter settings link.