Cisco Linksys NAS200, Quick Installation

Page: 7 / 75

Installation
While the Network Storage System
is booting up, the Power LED on the
front panel flashes.
Wait until you hear the Network
Storage System beep twice. (Be
patient; this can take several
minutes.)
The Power and Ethernet LEDs are
lit. The Disk 1 LED is lit if you have
installed a drive in the upper bay.
The Disk 2 LED is lit if you have
installed a drive in the lower bay.
Click Next .
The Setup Wizard automatically
searches for any Network Storage
System on your network.
If the Network Storage System
is not detected, check its cable
connections, and make sure it is
powered on. Then click
Search
Again
to locate the Network
Storage System.
Select the Network Storage System
that you want to set up. Then click
Next
.
L.
M.
Wait for Two Beeps Wait for Two Beeps
Network Storage System Detected Network Storage System Detected