Connecting to Access Point Ports
This section describes connecting the access point to PoE.
For connections outside the building where the equipment is installed, the following ports must be
connected through an approved network termination unit with integral circuit protection.10/100/1000
Ethernet Statement 1044
Danger
Connecting to the PoE IN or PoE OUT Port
Procedure
Step 1
Use shielded cables with a M12 X-Code plug to connect to the PoE IN or PoE OUT ports.
Ethernet cables must have an internal shield around the signal wires. There must be a contiguous ground between
the connector shell that interfaces with the IW3702 and the connector shell on the far end of the cable. Maximum
cable length should not exceed 100 meters.
Note
23
