Accessing the SIM Slots
Two USIM sockets are provided with easy access via a secured panel on the back side of the router. The SIM
Slots will be connected directly to the 4G radio.
Note
: The IR800 series of routers use the Mini-SIM (2FF). Specifications are:
• ISO/IEC 7810:2003, ID-000
• Length - 25mm, Width - 15mm, Thickness - 0.76mm
This section describes how to install and/or replace a SIM card. Ensure that the router is not mounted to a
wall, floor, or DIN rail.
CAUTION
: Do not touch any part of the exposed PCB circuit area when the SIM cover is removed.
WARNING:
The covers are an integral part of the safety design of the product. Do not operate the unit
without the covers installed. Statement 1077
WARNING:
Hot surface. Statement 1079
To access the SIM card in the Cisco IR807, follow these steps:
1.
Power off the router and disconnect the power cable from the power source.
2.
Place the router on its bottom and ensure that any installed antennas are carefully oriented or disconnected
to be out of the way.
3.
Remove the protective cover (
1
) over the SIM slots by unscrewing the screws and setting them aside.
1.
Locate the SIM card you wish to install/replace. SIM0 is the bottom and SIM1 is the top. The following
figure shows the slots with the protective cover removed.
Cisco IR807 Industrial Integrated Services Router Hardware Installation Guide
27
Installing the Router
Accessing the SIM Slots
