• By connecting a control device to the Cisco device through an
internet connection (Internet access)
6.2.1. Local access and login for initial configuration
NOTE
If your computer has a wireless WiFi card, you may have to
disable the card to avoid routing issues between the
computer's wired and wireless network interfaces.
To use the Configurator interface to access the Cisco FM3200 Base
directly, do the steps that follow:
Power ON the unit.
1.
2.
sequence to
boot
the
for
minute
one
Wait approximately
complete.
Connect one end of a CAT5/6 Ethernet cable to the computer that
3.
will be used to configure the Cisco FM3200 Base.
4.
Connect the other end of the Ethernet cable to the
Console
LAN
port on the Cisco FM3200 Base.
5.
Manually set the computer's IP address and Netmask to be
recognizable by the Cisco FM3200 Base. The correct settings are
as follows:
•
IP address:
192.168.0.10 (or any other IP address
belonging to subnet 192.168.0.0/255.255.255.0)
•
Netmask:
255.255.255.0
Launch the computer's web browser.
6.
7.
Enter the IP address of the Cisco FM3200 Base in the browser's
URL entry field.
• If the Configurator interface is shown immediately, proceed
• Alternatively, you may see the following window:
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved.
Page 43 of 176