Network Modules
The Firepower 9300 contains two network module slots that provide optical or electrical network interfaces.
Network modules are optional, removable I/O modules that provide either additional ports or different interface
types (1/10/40/100 G).
The Firepower network modules plug into the chassis on the front panel. You can also remove the divider
between the two network module slots and insert a double-wide network module.
For More Information
• See
10-G Network Module , on page 14
for a description of the 10-G network module.
• See
40-G Network Module , on page 15
for a description of the 40-G network module.
• See
100-G Network Module (Two Ports Single Wide), on page 16
for a description of the 100-G
two-port single-wide network module.
• See
100-G Network Module (Four Ports Single Wide), on page 17
• See
100-G Network Module (Double Wide) , on page 18
for a description of the 100-G double-wide
network module.
• See
Supported SFP/SFP+ and QSFP Transceivers, on page 26
for a list of supported SFPs.
• See
Remove and Replace the Single-Wide Network Module, on page 63
for the procedure for
removing and replacing single-wide network modules.
• See
Remove and Replace the Double-Wide Network Module, on page 66
for the procedure for
removing and replacing double-wide network modules.
10-G Network Module
The following figure shows the front panel of the 10-G network module (FPR9K-NM-8X10G). The
FPR9K-NM-8X10G is a single-wide module that supports hot swapping. The eight ports are numbered from
top to bottom, left to right.
The FPR9K-NM-8X10G is NEBS-compliant.
Note
You can fit four copper SFPs in either the top row of ports or the bottom row of ports. Both rows cannot be
populated at the same time, because of the port row spacing.
Note
Cisco Firepower 9300 Hardware Installation Guide
14
Overview
Network Modules
