Cisco expressway ce1100, Installation Manual

Page: 17 / 20

Note: You must set up and access the CIMC to instigate a reinstall. See Connect Using the CIMC Port, page 12 .
Reset the SD Card and Enable the Virtual Drive
1. Log in to the CIMC.
2. Navigate to Storage > Cisco FlexFlash > Controller Info .
3. Under Actions , click on Reset FlexFlash Controller and click yes in the popup window that appears. The
reset ensures your FlexFlash Controller is in the correct state.
4. Click the Virtual Drive Info tab.
5. Under Actions , click Enable/Disable Virtual Drive(s) .
6. In the Enable/ Disable VDS popup window, check the Hypervisor check box and click Save .
IRP Reinstall Using the KVM Console
1. Launch the KVM Console using the icon in the CIMC.
2. Power up the CE1100 and, when prompted, press
F2
to enter
Setup
.
3.
Select
Boot Options
and ensure that the
CiscoVD Hypervisor
is visible as one of the options.
Note: If the
CiscoVD Hypervisor
is not visible, you can select the
UEI: Built-in EFI Shell
boot option and
change it to
CiscoVD Hypervisor
.
4.
When prompted, press
F6
to enter the
Boot Menu
.
5. Select
CiscoVD Hypervisor
as the boot option.
6.
When prompted, type
y
and press
Enter
to proceed with the reinstall.
7. When asked whether to
keep any release keys if possible
, type
y
and press
Enter
.
8. You will be given the option to add option keys. This can also be done later on the web interface or CLI.
9. Type
b
and press
Enter
to reboot.
10. Connect using serial to complete the reset.
11. You will see the factory installation wizard.
12.
Your release key should be visible. Press
Enter
to proceed to the install wizard and follow the steps in
Configure the Cisco Expressway, page 13
Note: If the SD card is unable to locate your release key, contact the Cisco Technical Assistance Center (TAC) for
your release key and reapply it.
Disable the Virtual Drive After the Reinstall
1.
During the reboot, press
F2
to enter
Setup
.
2. Under
Boot Options
select the
CiscoVD Hypervisor
and disable it.
3.
Press
F10
to save and exit.
4. While your system is rebooting, return to the Virtual Drive Info tab — in the CIMC interface under Storage —
and uncheck the Hypervisor check box to disable it.
Specific Issues
Active Options Only Indicates ‘150 traversal calls’ or ‘3750 registrations’ for Large Deployments
To utilize the large-scale capabilities (500 traversal calls and 5000 registrations) of the Cisco Expressway, the
CE1100 unit must have an active 10 Gb network connection.
17
Cisco Expressway CE1100 Appliance Installation Guide
Troubleshooting