1-5
Cisco FlexWAN and Enhanced FlexWAN Modules Installation Guide
OL-8357-01
Chapter 1 Installing the FlexWAN and Enhanced FlexWAN Modules
Installing the FlexWAN and Enhanced FlexWAN Modules
Router#
show module
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
5 2 Supervisor Engine 720 (Active) WS-SUP720-BASE SAD0719027M
6 0 2 port adapter Enhanced FlexWAN WS-X6582-2PA SAD073103PD
Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
5 000c.ce63.e290 to 000c.ce63.e293 2.1 7.7(1) 12.2(TETONS_ Ok
6 00e0.aabb.cc00 to 00e0.aabb.cc3f 1.x 12.2(TETONS_ 12.2(TETONS_ Ok
Mod Sub-Module Model Serial Hw Status
--- --------------------------- ------------------ ------------ ------- -------
5 Policy Feature Card 3 WS-F6K-PFC3A SAD072000G6 1.1 Ok
5 MSFC3 Daughterboard WS-SUP720 SAD072001YS 1.2 Ok
Mod Online Diag Status
--- -------------------
5 Pass
6 Pass
--------------------------------------------------------------------------------
Note
The
status
field in the output of the
show module
command indicates by “Ok” that the module is
operational.
The
show module
command displays “Ok” status and “Mod Online Diag Status” only after the
FlexWAN or Enhanced FlexWAN module has booted completely. While the FlexWAN or Enhanced
FlexWAN module is booting (the STATUS LED is orange or red), the “Ok” status and the “Mod Online
Diag Status” is unknown.
Step 12
After you install the FlexWAN or Enhanced FlexWAN modules, you must connect the port adapter
cables and configure the port adapter interfaces.
For complete cabling and configuration information for the port adapters, refer to the documentation that
shipped with your port adapter.
