Step 4
Remove the new supervisor module from the shipping packaging, being careful to handle the module using only the
module
’
s metal tray or the front panel. Do not touch the printed circuit board or the connector pins.
Step 5
Pivot the two module ejector levers out and away from the faceplate
Figure 3: Installing the Supervisor Engine in the Chassis (Catalyst 4507R+E Shown)
Step 6
Grasp the switching module's front panel with one hand and place your other hand under the carrier to support the supervisor
module.
Step 7
Position the new module in the slot. Make sure that you align the sides of the module carrier with the slot guides on each
side of the chassis slot.
Step 8
Carefully slide the supervisor module into the slot. Pivot both ejector levers in simultaneously.
When installed correctly
•
The notches on both the ejector levers engage the chassis sides.
•
Both the ejector levers are parallel with the supervisor module faceplate to fully seat the module in the backplane
connector.
Always use the ejector levers when installing or removing a supervisor module. A module that is partially
seated in the backplane will not function correctly.
Note
14
