3-6
Catalyst 3650 Switch Hardware Installation Guide
OL-29734-01
Appendix 3 Configuring the Switch with the CLI-Based Setup Program
Entering the Initial Configuration Information
Uninstalling the Cisco USB Driver for Microsoft Windows Using the Setup.exe Program
Note
Disconnect the switch console terminal before uninstalling the driver.
Step 1
Run setup.exe for Windows 32-bit, or setup(x64).exe for Windows 64-bit, and click
Next
.
Step 2
In the
InstallShield
wizard for Cisco Virtual Com that is displayed, click
Next
.
Step 3
In the
Program Maintenance
window that is displayed, click the
Remove
radio button, and click
Next
.
Step 4
In the
Remove the Program
window that is displayed, click
Remove
.
Note
For Windows Vista or Windows 7, if a User Account Control warning is displayed, click
Allow - I trust
this program to proceed
.
Step 5
In the
InstallShield Wizard Completed
window that is displayed, click
Finish
.
Entering the Initial Configuration Information
To set up the switch, complete the setup program, which runs automatically after the switch is powered
on. You must assign an IP address and other configuration information necessary for the switch to
communicate with the local routers and the Internet. This information is also needed to use Device
Manager or Cisco Network Assistant to configure and manage the switch.
IP Settings
You require the following information from your network administrator to configure the switch:
•
Switch IP address
•
Subnet mask (IP netmask)
•
Default gateway (router)
•
Enable secret password
•
Enable password
•
Telnet password
Configuring the Setup Program
If your switches are stacked and there are multiple console connections to individual switches in the
stack, the initial setup dialog box is displayed on the console where you first press
Enter
.
To complete the setup program and the initial configuration for the switch:
Step 1
Enter
Yes
at the following two prompts:
Would you like to enter the initial configuration dialog? [yes/no]:
yes
