Cisco Catalyst 3560-X Series, Software Configuration Manual

Page: 127 / 1538

1-23
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
Chapter 1 Assigning the Switch IP Address and Default Gateway
Scheduling a Reload of the Software Image
When the switch is connected to a PC through the Ethernet management port, you can download or
upload a configuration file to the boot loader by using TFTP. Make sure the environment variables in
Table 1-5 are configured.
Scheduling a Reload of the Software Image
You can schedule a reload of the software image to occur on the switch at a later time (for example, late
at night or during the weekend when the switch is used less), or you can synchronize a reload
network-wide (for example, to perform a software upgrade on all switches in the network).
Note
A scheduled reload must take place within approximately 24 days.
SWITCH_NUMBER set SWITCH_NUMBER
stack-member-number
Changes the member number of a stack
member.
switch current-stack-member-number renumber
new-stack-member-number
Changes the member number of a stack member.
Note
This command is supported only on
Catalyst 3750-X switches.
SWITCH_PRIORITY set SWITCH_PRIORITY
stack-member-number
Changes the priority value of a stack member.
switch stack-member-number priority
priority-number
Changes the priority value of a stack member.
Note
This command is supported only on
Catalyst 3750-X switches.
Table 1-4 Environment Variables (continued)
Variable Boot Loader Command Cisco IOS Global Configuration Command
Table 1-5 Environment Variables for TFTP
Variable Description
MAC_ADDR Specifies the MAC address of the switch.
Note We recommend that you do not modify this variable.
However, if you modify this variable after the boot loader is up or the value
is different than the saved value, enter this command before using TFTP.
IP_ADDR Specifies the IP address and the subnet mask for the associated IP subnet of
the switch.
DEFAULT_ROUTER Specifies the IP address and subnet mask of the default gateway.