Cisco Catalyst 2960 Series, Configuration Manual

Page: 97 / 2288

C H A P T E R
2
Configuring Interface Characteristics
• Finding Feature Information, page 15
• Information About Configuring Interface Characteristics, page 15
• How to Configure Interface Characteristics, page 24
• Monitoring Interface Characteristics, page 38
• Configuration Examples for Interface Characteristics, page 39
• Additional References for the Interface Characteristics Feature, page 42
• Feature History and Information for Configuring Interface Characteristics, page 43
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to
http://www.cisco.com/go/cfn . An account on Cisco.com is not
required.
Information About Configuring Interface Characteristics
Interface Types
This section describes the different types of interfaces supported by the switch. The rest of the chapter describes
configuration procedures for physical interface characteristics.
The stack ports on the rear of the stacking-capable switches are not Ethernet ports and cannot be configured. Note
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
15