Cisco Catalyst 2960 Series, Configuration Manual

Page: 751 / 2288

C H A P T E R
29
Configuring IP Unicast Routing
• Finding Feature Information, page 669
• Information About Configuring IP Unicast Routing, page 669
• Information About IP Routing, page 670
• Configuring IP Unicast Routing, page 672
• Enabling IP Unicast Routing, page 672
• Assigning IP Addresses to SVIs, page 673
• Configuring Static Unicast Routes, page 675
• Monitoring and Maintaining the IP Network, page 676
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to
http://www.cisco.com/go/cfn . An account on Cisco.com is not
required.
Information About Configuring IP Unicast Routing
This module describes how to configure IP Version 4 (IPv4) unicast routing on the switch.
A switch stack operates and appears as a single router to the rest of the routers in the network. Basic routing
functions like static routing are available with .
In addition to IPv4 traffic, you can also enable IP Version 6 (IPv6) unicast routing and configure interfaces
to forward IPv6 traffic.
Note
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
669