4
Prepare for Rack-Mount Installation
Before you begin the rack-mounting tasks:
•
Decide whether or not you want to front-mount or rear-mount the chassis.
•
Decide whether or not you want to attach cable-management brackets to your chassis.
Note
If you install cable-management brackets, make certain that you use the specified rack-mount ear holes as stated
in the procedure and install the brackets after the cassia is mounted in the equipment rack.
•
Decide if two-post or four-post rack-mount equipment will be used.
3
Rack-Mount the Router
This section provides information for rack-mounting the router.
Attach the Rack-Mount Brackets—Chassis Front-Mounted
Figure 1
Front Rack-Mount Brackets for the Cisco ASR 1002 Router
To install the rack-mount brackets on a Cisco ASR 1002 Router for a front rack-mount configuration, follow these steps:
Step 1
Locate the threaded holes in the front sides of the chassis.
Step 2
Align the rack-mount bracket to the side of the router. Depending on which set of rack-mount bracket holes you choose
to use to attach the rack-mount bracket to the router, the chassis will either be recessed in the rack or protrude from
the rack.
Step 3
Position the front rack-mount bracket top hole with the chassis first top hole behind the side vent holes as shown in
Figure 1
.
Step 4
Insert and tighten the black screws on one side.
Step 5
Repeat Step 1 through Step 4 on the other side of the chassis. Use black screws to secure the rack-mount brackets to
the chassis.
Step 6
To install the cable-management bracket, see
“Attach the Cable-Management Bracket” section on page 8
.
1
Front rack-mount bracket ear and holes
3
Front rack-mount bracket screws
2
Front rack-mount bracket e
ASR 100
2
stat
pwr
min
maj
crit
SPA-4XOC
3-POS
S
T
A
T
U
S
0
1
2
3
C/A
A
/L
C/
A
A
/L
C/A
A
/L
C/
A
A
/L
SPA-4XOC
3-POS
S
T
AT
U
S
0
1
2
3
C/A
A
/L
C/A
A
/L
C
/A
A
/L
C/
A
A
/L
STAT
QE0
QE1
QE2
QE3
BOOT
CARRIE
R
LINK
PWR ST
AT
MTS
MGMT
AUX
CON
SPA-4XOC
3-POS
S
T
A
T
U
S
0
1
2
3
C/A
A
/L
C/
A
A
/L
C
/A
A
/L
C/
A
A
/L
3
280278
2
1
