Example:
write memory
Step 22
Verify that the running configuration is pointing to the correct node determined in Step 8:
Example:
show running-configuration
Step 23
Make sure that you are on the same network as the Cisco ASR 1000 Series Aggregation Services Router or VPN, and
start a WebEx meeting.
Step 24
Verify that network traffic is traversing the WebEx SPA card on the Cisco ASR 1000 Series Aggregation Services Router
by running the following commands:
Example:
show platform hardware qfp act interface if-name service-engine0/0/0 statistics
show platform hardware qfp act interface if name service-engine0/1/0 statistics
Step 25
Access the SIP console by using the request platform software console attach slot/subslot command.
Configuration Examples
This section includes an example for configuring a Cisco WebEx Node SPA installed in a Cisco ASR 1000
Series Router:
Router#
config t
Router(config)# ip nat inside source static 10.200.72.18 192.0.2.1
Router(config)#
interface service-engine 1/0/0
Router(config-if)#
ip address 10.200.72.17 255.255.255.252
Router(config-if)#
service-engine ip address 10.200.72.18 255.255.255.252
Router(config-if)#
service-engine default-gateway 10.200.72.17
Router(config-if)#
service-engine nameserver 10.100.4.10 10.100.4.20
Router(config-if)#
service-engine hostname spawma1 cisco.com
Router(config-if)#
service-engine wma-url https://wmabts.webex.com/wmams
Router(config-if)#
service-engine wma-passcode spawma1 2b51221d2c08f405913bbee1eb9f6ec6
Router(config-if)#
service-engine wma-token 45484b3e-8ea5-41e5-b050-49409006d14e
Router(config-if)#
no shutdown
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
380
OL-14127-17
Configuring the Cisco WebEx Node for the ASR 1000 Series Aggregation Services Routers
Configuration Examples