Maintenance and Upgrade Procedures for the ASA 5500-X
Install and Remove SFP Modules
Cisco ASA 5512-X, ASA 5515-X, ASA 5525-X, ASA 5545-X, and ASA 5555-X Hardware Installation Guide
57
10.
Carefully feed the flexible Regex circuit into the yellow channel on the chassis side (see
Figure 13
), and
connect the blue Regex cable connector end to the motherboard.
Figure 13
Feeding Regex Flexible Circuit through Channel and Connecting
11.
Close the green connector clamp.
12.
Install the chassis cover, and replace the chassis in the rack.
13.
Install the power cable, and restore power to the chassis. The LEDs will blink when traffic begins to pass.
Install and Remove SFP Modules
The ASA uses a small form-factor pluggable (SFP) module to establish Gigabit Ethernet connections; this module
is a hot-swappable input/output device that plugs into available SFP ports.
SFP Module Support, page 57
Install an SFP Module, page 58
Remove the SFP Module, page 58
SFP Module Support
Use only Cisco certified SFP modules on the ASA. Each SFP module has an internal serial EEPROM that is encoded
with security information. This encoding provides a way for Cisco to identify and validate that the SFP module
meets the requirements for the ASA.
For a list of the supported SFP modules, see the product data sheet at the following URL:
http://www.cisco.com/c/en/us/products/collateral/interfaces-modules/gigabit-ethernet-gbic-sfp-modules/pro
duct_data_sheet0900aecd8033f885.html
33
1
3
51
-A-
-A
-
-B-
-B
-
-A-
-A
-
-B-
-B
-
-B-
-B
-
-A-
-A
-
-B-
-B
-
-A-
-A
-
-B-
-B
-
-B-
-B
-
-B-
-B
-
-C-
-C
-
-B-
-B
-