34
Step 5
Enter the MAC address of the access point in the MAC Address field. You can also use the
config macfilter add
command to add a MAC filter entry to the controller.
Step 6
Select a WLAN ID or
Any WLAN
from the WLAN ID pop-up menu.
Step 7
Enter a description (32 characters maximum) of the access point in the Description field.
Step 8
Choose an interface from the Interface Name pop-up menu.
Step 9
Click
Apply
.
Step 10
Repeat this process to add other access points to the list.
Note
You can also use the controller CLI command
config macfilter add
to add a MAC
filter entry on the controller.
Step 11
On the menu bar, click
Monitor
to return to the Monitor Summary page.
Verifying Controller Association
To verify that your access point is associated to the wireless LAN controller, perform these steps:
Step 1
Log into your controller web interface (https) using a web browser.
Step 2
Click
Wireless
and verify that your access point MAC address is listed under Ethernet MAC.
Step 3
Log out of the controller and close your web browser.
Deployment Notes
Using a DHCP Server in a Layer 3 Mesh Network
To use a DHCP server in a Layer 3 mesh network, make sure the wireless LAN controller is in Layer
3 mode. You must also configure DHCP option 43 on the DHCP server. After the controller is
restarted, the access point receives IP addresses from the DHCP server.
Summary of Contents for Aironet 1550 Series
Page 58: ...58 ...
