2-49
Cisco Aironet 1530 Series Outdoor Access Point Hardware Installation Guide
OL-30864-01
Chapter 2 Installing the Access Point
Powering the Access Point
Figure 2-31
Inserting the Terminal Strip into the DC Power Opening in the Access Point Case
Figure 2-32
DC Power Opening in the Access Point Case
Step 9
Slide the cable gland with the rubber seal towards the access point, and screw the threaded end of the
body into the access point, and hand-tighten.
Step 10
Use an adjustable wrench, a 28-mm wrench to tighten the threaded end of the body to 15 lb-in.
Step 11
Use an adjustable wrench and tighten the thread-lock seal nut to 15 lb-in.
Step 12
Ensure that the antennas are connected to the access point before you apply power to the access point.
Step 13
Turn on the DC power at the designated circuits.
1
DC power opening in access point case. Also
see
2
Exploded view of the cable gland on the DC
power cable
352057
1
2
352054
