Cisco Aironet 1430 Series, Getting Started Manual, Page: 32 / 48

32
THIRD FCC DRAFT (CISCO CONFIDENTIAL)
Using the Web Browser Interface
Follow the steps below to delete the current configuration and return all bridge settings to the factory
defaults using the web browser interface.
Step 1 Open your Internet browser. You must use Microsoft Internet Explorer (version 5.x or later)
or Netscape Navigator (version 4.x).
Step 2 Enter the bridge’s IP address in the browser address line and press Enter . An Enter Network
Password screen appears.
Step 3 Enter your username in the User Name field.
Step 4
Enter the bridge password in the Password field and press Enter . The Summary Status page
appears.
Step 5
Click System Software and the System Software screen appears.
Step 6
Click System Configuration and the System Configuration screen appears.
Step 7
Click Default .
Note
If the bridge is configured with a static IP address, the IP address does not change.
Step 8 After the bridge reboots, you must reconfigure the bridge by using the Web browser interface,
the Telnet interface, or IOS commands.
Reloading the Bridge Image
If your bridge has a firmware failure, you must reload the complete bridge image file using the Web
browser interface or by pressing and holding the MODE button for around 30 seconds. You can use
the browser interface if the bridge firmware is still fully operational and you want to upgrade the
firmware image. However, you can use the MODE button when the bridge has a corrupt firmware
image.
Using the MODE button
You can use the MODE button on the bridge to reload the bridge image file from an active Trivial File
Transfer Protocol (TFTP) server on a PC connected directly to the power injector Ethernet port.
br1430gsg.fm Page 32 Thursday, November 20, 2008 1:59 PM