9
Pre-Installation Configuration Setup
Figure 3 shows the pre-installation configuration setup.
Figure 3
Pre-Installation Configuration Setup
Follow these steps to perform the pre-installation configuration.
Step 1
Make sure that the Cisco wireless LAN controller DS port is connected to the network. Use
the CLI, web-browser interface, or Cisco WCS procedures as described in the appropriate
Cisco wireless LAN controller guide.
a.
Make sure that access points have Layer 3 connectivity to the Cisco wireless LAN controller
Management and AP-Manager Interface.
b.
Configure the switch to which your access point is to attach. See
Deploying Cisco 440X Series
Wireless LAN Controllers
for additional information.
c.
Set the Cisco wireless LAN controller as the master so that new access points always join with
it.
d.
Make sure DHCP is enabled on the network or DNS resolution is available. The access point
must receive its IP address through DHCP or DNS resolution.
Controller
Layer
3
devices
Cisco Aironet
access points
272488
