4-19
Cisco 850 Series and Cisco 870 Series Access Routers Hardware Installation Guide
OL-5331-01
Chapter 4 Router Cabling Procedures
Connecting a G.SHDSL Line
Figure 4-15
Connecting the ADSLoISDN Port to an ADSL Line
Perform the following steps to connect the ADSL line to a cable wall jack:
Step 1
Connect the RJ-11 end of the ADSL cable to the ADSLoISDN port on the router.
Step 2
Connect the other RJ-11 end of the ADSL cable to the local ADSL connector port on the ADSL splitter
(provided by the ADSL service provider).
Step 3
Connect the unshielded Category 5 cable from the outside ADSL port on the splitter to a wall jack.
Connecting a G.SHDSL Line
This section applies to the Cisco 878 router only. To connect the router to a G.SHDSL line, perform the
steps given after
Figure 4-16
.
1
One end of the ADSL cable that connects to
the router
4
RJ-11 end of the ADSL cable that connects to
the splitter
2
ADSL splitter
5
Other end of the unshielded Category 5 cable
that connects to the wall jack
3
RJ-11 end of an unshielded Category 5 cable
that connects to the splitter
ADSL o ISDN
ISDN S/T
LAN
FE0
FE1
FE2
FE3
Cisco 876W
CONSOLE
AUX
RESET
+5,+12 VDC
LEFT
RIGHT / PRIMARY
117963
2
1
3
4
5
AUX
