![background image](http://html.mh-extra.com/html/cisco/7304-series/7304-series_installation-and-configuration-manual_65950057.webp)
4-5
Cisco 7304 Network Service Engine Installation and Configuration
OL-3967-01
Chapter 4 Removing and Installing the NSE
Removing the Slot Divider for a Redundant Configuration
Step 9
Place the NSE on an antistatic surface with its printed circuit board components facing upward, or in a
static shielding bag. If you are returning the network services engine to the factory, immediately place
it in a static shielding bag.
This completes the procedure for removing an installed NSE. For instructions on installing the NSE, go
to the
“Inserting the Network Services Engine” section on page 4-7
.
•
To prepare the chassis for installing a second network services engine, go to the
“Removing the Slot
Divider for a Redundant Configuration” section on page 4-5
.
•
To replace a single network services engine, go to the
“Inserting the Network Services Engine”
section on page 4-7
.
Removing the Slot Divider for a Redundant Configuration
You must remove the slot divider in slot 2 in order to install a second network services engine in a Cisco
7304 router. See
Figure 4-2
.
Figure 4-2
Cisco 7304 Slot Designation
1
Slot 4
3
Slot 0
2
Slot 5
4
Slot 2
DISK 0
LINK
GIGABIT ET
HERNET 1
EN
RX
SFP
TX
RJ45
LINK
GIGABIT ET
HERNET 1
EN
RX
SFP
TX
RJ45
CONSOLE
AUX
ACTIVE
NETWORK PR
OCESSOR ENGINE 100
LINK
GIGABIT ET
HERNET 1
EN
RX
SFP
TX
STANDBY
SYSTEM-U
P
C7304-NPE-G
100
RESET
RJ45
TX
LNK
RX
0
7300-6T3
6-PORT T3 DSU
STATUS
OIR
TX
LNK
RX
1
TX
LNK
RX
2
TX
LNK
RX
3
TX
LNK
RX
4
TX
LNK
RX
5
DISK 0
LINK
GIGABIT ET
HERNET 1
EN
RX
SFP
TX
RJ45
LINK
GIGABIT ET
HERNET 1
EN
RX
SFP
TX
RJ45
CONSOLE
AUX
ACTIVE
NETWORK PR
OCESSOR ENGINE 100
LINK
GIGABIT ET
HERNET 1
EN
RX
SFP
TX
STANDBY
SYSTEM-U
P
C7304-NPE-G
100
RESET
RJ45
84846
3
4
1
2