3-2
Cisco Secure Router 520 Series Hardware Installation Guide
OL-12892-01
Chapter 3 Router Mounting Procedures
Mounting the Router on a Wall
To install the router on a desktop, table, or other flat surface, follow these steps:
Step 1
Place the unit upside-down on the flat surface.
Step 2
Attach the four rubber pads to the recessed areas on the bottom of the unit.
Step 3
Place the unit right-side-up on the flat surface.
Step 4
If you have a wireless router, connect the radio antenna to the router (see the
“Connecting a Radio
Antenna to a Wireless Router” section on page 3-1
).
Step 5
Place the power supply unit on a desktop near an AC power source. Do not stack the power supply on
the router.
Mounting the Router on a Wall
You can mount the Cisco Secure Router 520 Series router on a wall or other vertical surface. There are
two mounting-screw holes on the bottom of the router for mounting the unit.
Figure 3-1
shows the
mounting-screw holes.
Figure 3-1
Mounting-Screw Holes on the Bottom of the Cisco Secure Router 520 Series Router
231565
2
2
1
8.25 in. (20.9555 cm)
1
Front panel facing upward
2
Mounting-screw holes
Summary of Contents for 520 Series
Page 5: ...Contents v Cisco Secure Router 520 Series Hardware Installation Guide OL 12892 01 I N D E X ...
Page 6: ...Contents vi Cisco Secure Router 520 Series Hardware Installation Guide OL 12892 01 ...
Page 12: ...xii Cisco Secure Router 520 Series Hardware Installation Guide OL 12892 01 Preface ...
