28-18
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Software Configuration Guide
—
Release 8.2GLX
78-15908-01
Chapter 28 Power Management
Configuring PoE
System Name System Location System Contact CC
------------------------ ------------------------ ------------------------ ---
Switch#
Migrating a Supervisor Engine II from a Catalyst 4006 Switch to a Catalyst 4500
Series Switch
To migrate your supervisor engine from a Catalyst 4006 switch to a Catalyst 4503 or 4506 switch,
perform this task:
Configuring PoE
These sections show how to configure PoE for the Catalyst 4500 series switches and the Catalyst 4006
switch.
Setting the Power Mode of a Port or Group of Ports
To set the power mode of a port or group of ports, perform this task in privileged mode:
Task
Command
Step 1
Change the nondefault configuration mode to
text and specify the configuration file to use at
boot up.
set config mode text bootflash:switch.cfg
Step 2
Save the current nondefault configuration to
NVRAM.
write memory
Step 3
Save the configuration on the Catalyst 4006
switch.
copy config flash
Step 4
Remove the supervisor engine from the
Catalyst 4006 switch and insert it into the
Catalyst 4500 series switch.
–
Step 5
Clear the current configuration.
clear config all
Step 6
Load the saved configuration.
configure bootflash:switch.cfg
Step 7
If you have only one power supply in your
Catalyst 4506 switch, set the power budget to 1.
If you have two power supplies, set the power
budget to 2.
set power budget 1
Task
Command
Set the power mode of a port or group of ports.
set port inlinepower mod/port {[auto | static]
[max-wattage] | off}