4021196 Rev A
67
Control Access to the Gateway
Access Restrictions User Setup Page Description
Use the descriptions and instructions in the following table to configure the user
setup for your residential gateway. After you make your selections, click
Save
Settings
to apply your changes or
Cancel Changes
to cancel.
Section Field
Description
User
Configure
Add User
Allows you to add a new user profile. Enter the name of the user and click the
Add User
button to add the user to the list.
User Settings
Allows you to edit a user profile by using the drop-down menu to edit a user profile. The
drop-down menu allows you to recall the profile to be edited. User names and passwords
are case-sensitive.
Make sure to check the
Enable
box to activate the user profile. If a profile is not active, that
user will not have any access to the Internet.
To remove a user profile, use the drop-down menu to select the user to be removed and
click the
Remove User
button.
Password
Enter the selected user's password in this field. Each user must enter their User Name and
Password each time they use the Internet. User names and passwords are case-sensitive.
Note:
The residential gateway will allow each user access to the Internet, subject to the
rules selected on this page for that user.
Re-Enter Password
Re-enter the same password for confirmation of the password in the previous field.
Trusted User
Check this box if the currently selected user is to be designated a trusted user. Trusted
users are not subject to Internet access rules.
Content Rule
Select the Content Rule for the current user profile. Content Rules must first be defined by
going to the Rules Configuration page. You can access the Rule Configuration page by
clicking on the “Basic Rules” tab on this page.
Time Access Rule
Select the Time Access Rule for the current user profile. Time Access Rules must first be
defined by going to the Time of Day Rules page. You can access the Time of Day Rules
page by clicking on the “Time of Day Rules” tab on this page.
Session Duration
1440 minutes [Factory default when a user is created. Otherwise, it is 0 (zero)].
Enter the amount of time in minutes that the user will be granted Internet access beginning
at the time they sign on using their User Name and Password.
Note:
Set the Session Duration to 0 (zero) to prevent session timeout.
