C H A P T E R
2-1
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 PRI Gateway and 3545 Serial Gateway Releases 5.6 and 5.7
OL-17011-01
2
Installing the Cisco Unified
Videoconferencing 3545 Gateway
•
Physical Description, page 2-1
•
Requirements for Installation, page 2-3
•
Verifying the Package Contents, page 2-4
•
Mounting the Cisco Unified Videoconferencing 3545 Chassis in a 19-inch Rack, page 2-5
•
How to Install the Gateway, page 2-6
•
How to Perform the Initial Gateway Configuration, page 2-10
•
Connecting the Gateway to the Network, page 2-15
•
Connecting PRI Lines to the Gateway, page 2-15
•
Connecting Serial Lines to the Gateway, page 2-15
•
Serial Gateway Cable Connections and Pin-outs, page 2-16
•
Connecting the Gateway to a Power Source, page 2-27
•
Accessing the Gateway Administrator Interface, page 2-27
•
Online Help Registration, page 2-28
Physical Description
•
Gateway Module, page 2-1
•
Cisco Unified Videoconferencing 3545 PRI Gateway RTM, page 2-2
•
Cisco Unified Videoconferencing 3545 Serial Gateway RTM, page 2-3
Gateway Module
The gateway module has a 10/100BaseT Ethernet port on the front panel that uses an RJ-45 connector
to connect to the network. There is an asynchronous, 9-pin serial port that you can use with a
hyperterminal program to configure and monitor the module.
Figure 2-1
shows the front panel components of the gateway module.
Table 2-1
describes these
components.
