2-25
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 MCU Releases 5.6 adn 5.7
OL-17013-01
Chapter 2 Installing the Cisco Unified Videoconferencing 3545 MCU
How to Perform the Initial EMP Configuration
Changing the Configuration Software Password
You can use the serial port to change the configuration software password.
Procedure
Step 1
At the prompt, enter
P
to change the configuration software password and press
Enter
.
The user profile screen displays as follows:
Enter user name:
Enter new password:
Step 2
At the Enter user name prompt, enter the new user name and press
Enter
.
Step 3
At the Enter user password prompt, enter the new password and press any key to return to the EMP Main
menu.
Changing the Security Level
You can use the serial port to change the security level. Security levels are as follows:
•
0 (low)—Allows SNMP, Telnet, HTTP, FTP, and ICMP to access the MCU.
•
1 (medium)—Allows access to the MCU only through SNMP, HTTP and ICMP.
•
2 (high)—Allows only HTTP to access the MCU.
Procedure
Step 1
At the prompt, enter
S
to configure the network security level and press
Enter
.
The security level screen displays as follows:
The current security level is [0 low].
Enter a new security level (0-low, 1-medium. 2-high):
Step 2
Enter the new security level required and press
Enter
.
The updated security level screen displays as follows:
The current security level is [0 low].
Enter a new security level (0-low, 1-medium. 2-high):
2
Board security level changing to [2 high]:
Set icmpRequestBlock to 2
The new security level is [2 high].
Step 3
The EMP Main menu displays.
