2-16
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 MCU Releases 5.6 adn 5.7
OL-17013-01
Chapter 2 Installing the Cisco Unified Videoconferencing 3545 MCU
Removing the MCU and EMP
Caution
Do not force the connection. Forcing the connection can bend or damage the pins in the
connector inside the chassis.
Note
If you are installing the MCU or the EMP module and the power to the chassis is on, the SWAP
RDY LED on the module front panel turns blue when you slide the module into the chassis as
far as it will go. This means that you can secure the module safely. The LED turns off when the
handles are closed.
Step 8
Snap the handles forward to secure the MCU or the EMP module in the slot.
Step 9
Secure the MCU or the EMP module screws.
Caution
Blank faceplates and cover panels serve three important functions: they prevent exposure to
hazardous voltages and currents inside the chassis; they contain electromagnetic interference
(EMI) that might disrupt other equipment; and they direct the flow of cooling air through the
chassis. Do not operate the system unless all cards, faceplates, front covers and rear covers
are in place.
Removing the MCU and EMP
This section describes how to remove the MCU or the EMP from the Cisco Unified
Videoconferencing 3545 chassis.
Procedure
Step 1
Loosen the MCU or the EMP module screws.
Step 2
Press the red buttons and open the handles of the MCU or the EMP module (see
Figure 2-5
).
