Cisco 3310 Mobility Services Engine, Getting Started Manual

Page: 32 / 60

4-4
Cisco 3310 Mobility Services Engine Getting Started Guide
OL-17304-02
Chapter 4 Rack Mounting
Mounting the Mobility Services Engine in a Four-Post Rack
Figure 4-2 Installing the Rack Handle
Step 5
Repeat Step 3 and Step 4 on the opposite side of the mobility services engine.
Step 6 Plug all peripheral devices and the AC power cable into the mobility services engine.
Mounting the Mobility Services Engine in a Four-Post Rack
Warning
Stability hazard. The rack stabilizing mechanism must be in place, or the rack must be bolted to the
floor before you slide the unit out for servicing. Failure to stabilize the rack can cause the rack to tip
over.
Statement 1048
Warning
The chassis should be mounted on a rack that is permanently affixed to the building. Statement 1049
This section contains the following topics:
•
Contents of the Four-Post Installation Kit, page 4-4
• Attaching Chassis Brackets to the Chassis, page 4-6
•
Attaching the Rail Hardware to the Rack, page 4-6
• Installing the Chassis into the Rack, page 4-7
Contents of the Four-Post Installation Kit
The four-post installation kit includes individual left and right slide rail assemblies and chassis brackets.
Figure 4-3 shows the details of the four-post hardware kit.
Note
Each slide rail assembly consists of three pieces that slide to extend the rail to its full length. To reach
the features of the innermost piece, such as the release buttons, you must grasp the end of the innermost
piece and pull it firmly out of the piece that contains it (the slide rail assembly is the top item displayed
in
Figure 4-3 ).
00
Series
e S
er
ver
2
3
111
8