2-13
Cisco Catalyst Blade Switch 3020 for HP Hardware Installation Guide
OL-8914-02
Chapter 2 Switch Installation
Running Express Setup
Step 1
Wait for the switch module to complete POST. It might take several minutes for the switch module to
complete POST.
Step 2
Verify that POST has completed by confirming that the system and status LEDs remain green.
Step 3
If the switch module fails POST, the system LED turns amber. If the POST fails, see the
“Understanding
POST Results” section on page 3-1
to determine a course of action. POST errors are usually fatal. Call
Cisco Systems immediately if your switch module fails POST.
Step 4
Wait approximately 2 minutes for the switch module to get the software image from its flash memory
and begin autoinstallation.
Step 5
Using a PC that is connected to the same network segment as the blade server Onboard Administrator,
access the Onboard Administrator in a browser window.
Step 6
Click
Enclosure > Interconnect Bays
to open the Interconnect Bay Summary window where you can
find the assigned IP address of the switch module fa0 interface in the Management URL column. (See
Figure 2-8
.)
Figure 2-8
HP Onboard Administrator Window
Step 7
Click the IP address hyperlink for the switch module from the Management URL column to open a new
browser window. The Device Manager window for the switch module opens.
Step 8
On the left side of the Device Manager GUI, click
Configuration
>
Express Setup
.
