Cisco 2010, Hardware Installation Manual

Page: 61 / 92

4-7
Cisco Connected Grid Routers 2010 Hardware Installation Guide
OL-21559-01
Chapter 4 Configuring the Router
Performing the Initial Configuration on the Router
Router> enable
Password: password
Router# setup
•
Modify the existing configuration or configure additional features by using the CLI.
Router> enable
Password:
password
Router# configure terminal
Router(config)#
Using Cisco Configuration Professional Express
Use Cisco Configuration Professional Express web-based application to configure the initial router
settings. See
Cisco Configuration Professional Express User Guide on www.cisco.com for detailed
instructions.
For help with interface and port numbering, see the “Slot, Port, and Interface Information” section on
page 1-6 .
Using Cisco IOS CLI—Manual Configuration
This section shows you how to access the command-line interface (CLI) to perform the initial
configuration on the router.
If the system configuration dialog message does not appear, a default configuration file was installed on
the router prior to shipping. See the
“Using Cisco Configuration Professional Express” section on
page 4-7 to configure the router.
For help with interface and port numbering, see the “Slot, Port, and Interface Information” section on
page 1-6 .
Step 1
Enter the following answer when the system message appears on the router.
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]: no
Step 2
Press Return to terminate autoinstall and continue with manual configuration:
Would you like to terminate autoinstall? [yes] Return
Several messages are displayed, ending with a line similar to the following:
...
Copyright (c) 1986-2009 by cisco Systems, Inc.
Compiled <
date
> <
time
> by <
person
>