Connecting the Router to the LAN
Cisco 1600 Series Router Hardware Installation Guide
2-6
Connecting to a 10BaseT Ethernet
You must supply an Ethernet hub and an RJ-45-to-RJ-45 cable for this connection. Follow
these steps to connect the router to a 10BaseT Ethernet LAN:
Step 1
Connect one end of the Ethernet cable to the 10BASE T port.
Step 2
Connect the other end of the cable to one of the ports on the 10BaseT hub.
Step 3
Check the following LEDs:
•
LNK LED (rear panel, next to 10BaseT port)—On when the router is
correctly connected to the 10BaseT Ethernet LAN.
•
LAN ACT LED (front panel)—On when there is traffic on the Ethernet LAN.
Figure 2-3
10BaseT Port to Ethernet Hub Connection (Cisco 1601 Shown)
DO NOT INSTALL ANY WAN
MODULE WITH POWER ON
OK
WIC
OK
LNK
H7198
10BaseT port
10BaseT link LED
AUI
8
7
1
10BaseT hub
Straight-through
Ethernet cable
Summary of Contents for 1601 - Router - EN
