VCC-F52U25CL
Rev.900-668-31-01
©2010 CIS Corporation. All rights reserved.
18
X is the code to respond when the camera side detects an error.
Error details can be checked with 4 digits, 3
rd
to 6
th
bytes.
0101 Address value error
0102 Command error
0103 Data value error
0104 Data length error (over 14 byte)
Remote controller address
Note: Do not write the data into the address other than specified, since it may cause the
damages or malfunction of the camera.
Remote controller data
Set the decimal number (000
～
255) for the remote controller data. Please be noted to set any
dummy data at read control mode.
CR
Be sure to input “CR” to confirm the end of the command.
※
Note: When setting the data with 2 Byte, High Byte shall be set first, then Low Byte to the next.
The camera rewrites the internal resister when receiving Low Byte.
10.
Initial Settings
Function
Address Data
Gain
001
0: 0 dB
E-Shutter
002
0: 1/30s(Off)
White Balance
003
1: 3200K
Trigger Mode
004
0: Normal Trigger Mode (Trigger Mode Off)
Trigger Polarity
011
0: Positive Input
Trigger Input
012
0: Camera Link (CC1) Input
Output Data Select
013
0: 24bit RGB Output Data
Gamma Mode
014
0: Gamma OFF (1.0)
Partial Scan Mode
015
0: Full Frame Scan Mode
Partial Scan Total Line
021&022 1251:
Read Only
