VCC-SXCXP3NIR
Rev.905-0133-00
©2018 CIS Corporation. All rights reserved.
19
9.
Sequence Control Function
This is a function to select one set of parameter out of the preset several parameter sets per trigger input, and apply it
to the camera.
・
The maximum eight kinds of parameter sets can be set in advance. The following parameters can be set per
parameter set.
Settable parameter
：
Shutter and Gain.
・
Operation sequence is specified as "Index". Specify the parameter set number to be applied for the maximum of
eight indexes.
・
There are three control modes; trigger mode, burst mode, and index mode.
・
Please refer to the chart below for the settable AquisitionMode (Camera operational mode) and SequencerActivation
(Start operation) correspond to each sequence mode.
9.1
Basic Operation for Sequence Control
Please follow the step-by-step instructions below to use sequence control function.
①
AquisitionControl --- TriggerSelectorAndActivation Setting
This is to set camera operational mode.
②
Sub-sampling, ROI settings
Please turn OFF SubsamplingMode. Please set ROI of ImageFormatControl to ROIQuickChangeOff.
This does not work with sequence control function.
③
Set the parameter table (SequencerParameterSetSelector) for sequence
Please set ExposureTime and Gain of each parameter set.
④
Set the parameter set to be used for sequence
（
ParameterIndexNumber), index loop count
(IndexLoopCount), entire sequence loop count (SeqencerLoopCount), and the range of index to be used.
(ActiveIndexNumber)
⑤
SequencerControl --- SequencerActivation
This is to set the start operation of sequence mode. By setting any preferred [SequencerActivation] from Off,
the camera will become stand-by status for a trigger.
SequencerControl
[SequencerActivation]
◎
◎
◎
◎
FrameStartPredfined
◎
◎
◎
◎
FrameStartIndexselector
◎
FrameBurstStartEdge
FrameBurstStartLevel
FrameBurstStartSoftware
F
ra
m
e
B
urs
tSt
art
F
ram
e
S
tar
tL
e
v
e
lL
o
w
F
ra
m
e
S
ta
rt
L
e
v
e
lHi
g
h
F
ram
e
S
tar
tF
al
lin
g
E
d
g
e
F
ram
e
S
tar
tR
is
in
g
E
d
g
e
AcquisitionControl
AquisitionMode
[TriggerSelectorAndActivation]
バーストモード
【シーケンス動作モード】
トリガーモード
インデックスモード
【
Sequence Operational Mode
】
Trigger Mode
Index Mode
Burst Mode
