VCC-FC20V49PCL
Rev.900-734-33
©2014 CIS Corporation. All rights reserved.
18
10.
Remote Interface Function
Camera can be controlled by external computers and others via camera link interface.
(1)The settings for RS-232C are as follows.
Baud Rate
:
9600bps,19200bps,38400bps,57600bps,115200bps
Data
:
8bit
Stop bit
:
1bit
Parity
:
None
XON/XOFF
:
not controlled
(2) Control code
・
The total control code is 14 bits, which conforms to ASCII code.
・
The control code consists of camera No. process code, remote controller address, remote
controller data, and CR. Execute Read/Write through PC, and the camera will reply the data.
1
2
3
4
5
6
7byte
目
8 9
10
11
12
13
14
Camera No.
Process code
Remote
controller
address
Remote controller
data
CR
000000: Common No.
Dedicated Camera No.
“R” Read mode Please refer to
the address
table of 6.
Function
setting.
000
～
255
0Dh
“W” Write mode
“C”Camera
mode
Camera No
Please send the common code, “000000”, consist of 6 bytes of characters/numeric strings.
The returned data from the camera shall be the dedicated camera No assinged for that specific
camera.
Process code
Input any one of R, W, or C to the process code.
R (read mode) is to read the data of remote controller address.
Please be noted to set any dummy data (000
～
255) to 11
th
～
13
th
, since a command shall consists of
14 bytes.
W (write mode) is to write the data to the remote controller address.
Please be noted that the data cannot be saved into EEPROM of the camera.
(Reboot the camera, and the data is reset to the initial setting.)
To save the data into EEPROM, please refer to Clause 5.Function Setting.
Note: Once the data was saved into EEPROM, it may not be reset to t he initial settings
.
C is the code to send the data back from the camera.
Note: Do not set code C when sending the data from PC side.
