Setup when access point connected directly to a computer or to a LAN using the
same subnet (Typical Setup-XP instructions)
:
1.
S
elect
Start
2.
Select
Control Panel
3.
Click on
Network Connections
4.
Click on the
Local Area Network
icon
5.
Select
Properties
6.
Double-click the
Internet Protocol (TCP/IP)
line (figure 3.0)
7.
Select
Use the following IP address
and enter in an IP address in the 192.168.96.1
through 254 range.
NOTE:
This number cannot be the same as the access point or
any bridge. Use 255.255.240.0 for the subnet (figure 3.1) click
OK
twice to close
out the Internet Protocol/LAN properties. The computer is now ready to
send/receive data via from the access point.
8.
Open your web browser and type the IP address that is located on the silver
sticker on top of the access point into the address bar and press
ENTER
. The
access point login screen should appear. If this is not the case, verify steps 1-7
Figure 3.0
Figure 3.1
Setup when access point is connected to a switch, router or hub where the
Drive by
Download
TM
network and LAN are on different subnets: (XP Instructions)
Rev C
Page 10
11/30/2011
Copyright © 2011 by Cirus Controls, LLC. All Rights Reserved. No part of this material may be
reproduced in any form without the express written permission of Cirus Controls LLC.
NOTE:
the local network administrator will need to supply information
for this type of setup
.
Note: step 7 is important verify this before proceeding.
