11
4.
Connect the shafts together and to the actuator push rod
following the sequence from the above pictorials.
The recommended procedure is:
-
Identify the top connector bridge (white nylon pieces)
with un-threaded large holes (pictorial A) and align the
holes of shafts/Absylux connectors with the conical posts
of the said bridge (pictorial B).
-
Pass two ¼-20 -1.5” long nylon thumb screws through the
holes of top connector bridge and shafts/Absylux
connectors then screw them in the bottom connector
bridge as shown in pictorial C.
-
If it becomes hard to screw the thumb screws one can
press the whole assembly against a hard flat surface with
the bottom connector bridge down (pictorial D) until a
result like shown in pictorial E is obtained.
-
Tight the thumb screws so that both the top and bottom
connector bridges touch the shafts/Absylux connectors.
Do not over tight.